* Measure and mark the location of the first panel on the framing. At one end of the wall, measure and mark the top edge of the panel’s raised area. Drive a nail and run a level
mason’s line across the wall 1" from the framing. Install the first panel with drywall screws, so the top edge of the raised area is level with the mason’s line.
* Install subsequent panels so the raised top edge is level with the mason’s line. Also leave an equal distance between the sides of the raised areas of each panel. At corners,
make sure to account for panel overlap when making cuts.
* Variation: To wrap an inside corner, score the back of a panel using a T-square and sharp utility knife, being careful not to pierce the front face of the panel. Gently snap back the
panel, leaving the face paper intact. Fill the void with a bead of adhesive to reinforce the panel, then install it immediately.
* After all designer panels are installed, finish the rest of the wall and fill gaps with standard drywall of the same thickness. The designer panels can be taped and finished in the
same manner as standard drywall. At outside corners, install corner bead.
